Wiring of Power Circuit for Controlling Power Devices
WIRING OF POWER CIRCUIT FOR CONTROLLING POWER DEVICES
Aim :
To wire up a circuit with one lamp controlled by one switch with addition of plug point in surface conduit system of wiring as per the given layout & check the conditions.Also prepare the estimation.
CONDITIONS :
S1↑ S2↑ L1 Dark P Off
S1↓ S2↓ L1 Bright P On
Tools required :
Screw driver, line tester, cutting plier, stripper, hammer, hack saw, pocker
Estimation
Sl.No | Name of Material | Specification | Quantity | Unit |
1 | PVC Conduit | 20 mm | ||
2 | PVC insulated Copper wire | 1 mm2, , 1100 V grade | ||
3 | Flush Type SPST Switch | 6A, 240 V | ||
4 | Switch box(Gang Box) | 75×50×25 mm | ||
5 | Steady batten lamp holder | 6 A, 250 V | ||
6 | Incandescent Bulb | 60 W, 240 V | ||
7 | Saddle clips | 20 mm | ||
8 | PVC Round block | 75 X 25 mm | ||
9 | 4 way Junction box | 20 mm | ||
10 | Neutral Link | 6 A, 240 V | ||
11 | Kitkat type fuse unit | 6 A, 240 V | ||
12 | Screws | 13×4mm | ||
13 | 16×8mm | |||
14 | 30×8mm | |||
15 | Bend | 20mm | ||
16 | 3 pin plug point | 6A,240 V |
Procedure :
- Cut the Conduits in the required length (20cm) using Hack saw.
- Fix the conduits ,junction box ,switch box in required positions as per the lay out using saddles and screws.
- Run the wire through conduits, as per the given circuit diagram & then fix the Round block,switches,holder in required positions using screws.
- Check the circuit before applying the supply
- Give the single phase supply through a fuse and neutral link
- Check the conditions
Layout
Circuit Diagram :
Result :
Recent Comments