Category: Uncategorized

ANGULAR MEASURING INSTRUMENTS

ANGULAR MEASURING INSTRUMENTS

Vernier Bevel Protractor •The bevel protractor is a type of protractor t h a t is circular and ha s a pivotedarm used for measuring and marking of angles.•The basic protractor is most commonly...

Characteristics of LVDT

AIM: To study the characteristics of LVDT Position sensor. EQUIPMENTS REQUIRED: LVDT Trainer Kit ,Multimeter , Patch chords THEORY: The most widely used inductive transducer to translate the linear motion into electrical signals is...

Characteristics of Thermistor

AIM: To study the temperature v/s voltage characteristics of Thermistor. COMPONENTS REQUIRED : Thermometer, Heating coil, glass container, Thermistor trainer kit THEORY: A thermistor is a type of resistor whose resistance strongly depends on...

Characteristics of RTD

AIM: To study the temperature v/s voltage characteristics of RTD. COMPONENTS REQUIRED : Thermometer, Heating coil, glass container,RTD trainer kit THEORY: Resistance Temperature detector (R T D) is a temperature measuring sensor. It is...

Calibration of single phase energy meter by phantom loading

AIM: To calibrate the given single phase wattmeter by phantom loading at UPF and at 0.5pf. APPARATUS REQUIRED: Voltmeter Ammeter Wattmeter Lamp load  Energy meter THEORY When current rating of the meter under test...

Calibration of single phase energy meter by direct loading

AIM: To calibrate the energy meter by direct loading. APPARATUS REQUIRED: Voltmeter Ammeter  Wattmeter Lamp load  Energy meter THEORY: The process of comparing of an instrument with standard or absolute instrument is called calibration....

Calibration of ammeter using slide wire potentiomter

AIM: To calibrate the given ammeter ( 0 – 5)A using slide wire potentiometer. EQUIPMENTS REQUIRED: Ammeter , Slide wire potentiometer Kit, Standard cell , Galvanometer, Standard resistance box THEORY: A potentiometer instrument for...

Bistable Multivibrator

AIM  To set up an bi stable multivibrator using transistors, study its performance and observe the wave form at various points. COMPONENTS AND EQUIPMENTS REQUIRED PROCEDURE 1. Verify the condition of all components. 2....

error: Content is protected !!