Category: Lab Manuals

AC MUSH WINDING AIM:          Draw a Mush winding diagram for a 4 poles, 36 slots 3 phase armature using Auto cad software. PROCEDURE:          The following general commands are used to draw the...

UN-BIFURCATED THREE PHASE CONCENTRIC WINDING AIM: To draw concentric un- bifurbcated winding diagram with two planes over hang, for a three phase, 48 slots, 8 poles AC armature. PROCEDURE: Step 1: Set the limits...

DC  WAVE  WINDING AIM: Design and draw a developed DC simple wave winding diagram for a DC Machine having 4 poles, 34 armature conductors using Auto cad software. PROCEDURE:          The following general commands...

DC LAP WINDING AIM: Design and draw a developed DC lap winding diagram for a DC Machine having 6 poles, 36 armature conductors for a single turn coil using Auto cad software. PROCEDURE:         ...

PIN INSULATOR AIM: Design and draw the half sectional elevation of pin insulator using Auto cad software. PROCEDURE: The following general commands are used to draw the half sectional elevation of pin insulator diagram...

CROSS LINKED POLYETHYLENE CABLE AIM:– Draw the cross sectional elevation of XLPE Cable using Auto cad software. PROCEDURE: The following general commands are used to draw the cross sectional view of XLPE cable in...

WIRING OF POWER DISTRIBUTION ARRANGEMENT USING SINGLE PHASE MCB, DISTRIBUTION BOARD WITH ELCB, MAIN SWITCH AND ENERGY METER Aim : To design and wire up the circuit of main board and a consumer board...

GODOWN WIRING Aim : To wire up a circuit with three lamps controlled by three switches in surface conduit system of wiring as per the given layout & check the conditions .Also Prepare the...