Wiring of Simple Light Circuit for Controlling Light/Fan Point

1 – WIRING OF SIMPLE LIGHT CIRCUIT FOR CONTROLLING LIGHT/FAN POINT

Aim :

To wire up a circuit with one lamp controlled by one switch in surface conduit system of wiring as per given layout and check the conditions.Also Prepare the estimation.

CONDITIONS

S1↑    L1 Dark

S1↓  L1 Bright  

Tools required

Screwdriver, line tester, cutting plier, wire stripper, hammer, hacksaw, poker

Estimation

Sl.NoName of MaterialSpecificationQuantityUnit
1PVC Conduit20 mm  
2PVC insulated Copper wire1 mm2, , 1100 V grade  
3Flush Type SPST Switch6A, 240 V  
4Switch box(Gang Box)75×50×25 mm  
5Steady batten lamp holder6 A, 250 V  
6Incandescent Bulb60 W, 240 V  
7Saddle clips20 mm  
8PVC Round block75 X 25 mm  
93 way Junction box20 mm  
10Neutral Link6 A, 240 V  
11Kitkat type fuse unit6 A, 240 V  
12Screws13×4mm  
  16×8mm
  30×8mm

Procedure

  • Cut the Conduits in the required length (20cm) using Hack saw.
  • Fix the conduits ,junction box ,switch box in required positions as per the lay out using saddles and screws.
  • Run the wire through conduits, as per the given circuit diagram & then fix the Round block,switches,holder in required positions using screws.
  • Check the circuit before applying the supply
  • Give the single phase supply through a fuse and neutral link
  • Check the conditions

     LAY OUT

 CIRCUIT DIAGRAM

Result :

You may also like...

error: Content is protected !!